Jump to content

Dead In The Scrub !!


Recommended Posts

Making the screws too tight weakens the plastic part of the handle I think.  The one I made had no screws!

  • Like 2
Link to comment
Share on other sites


I had the same problems since the SD2000, so I cut a piece of stainless pipe which fitted over the shaft after I cut it down the middle and opened it up slightly. I then welded another piece of stainless pipe to the first mentioned at the correct angle and then pop riveted the sleeve onto the detector shaft in the appropriate position for my arm. When the handles came out with the button in the top I glued a drilled out piece of wooden dowel into the top of the handle for the button switch and ran the wiring down the inside of the handle and out through a hole I had made in the very bottom of the handle. Works  a treat and will never break.

  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...