15 posts in this topic
Salutation at this very informative website us below: (and yes, do click on those read this and this links too)
Prepared by: Randy L. Korotev
Department of Earth and Planetary Sciences
Washington University in St. Louis
Please don't contact me about the meteorite you think you've found until you read this and this.
A couple of days ago went to a new area, no diggings around, and no finesse to my detecting, I`m not working low and slow trying to hear faint changes in the threshold, I`m hooking in and covering as much ground as I can. Two days ago I hit a point oner that I thought for sure was a birdshot and yesterday I got this one. So for about nine hours detecting I got 2, the gold is hardly leaping out of the ground all over the place, but it`s a big area and I`m still young (i wish). 2.69 grams. Dave
Working for a living is getting in the way of fun. I'm in a gold ring slump. Last one was the day before Christmas. We managed to get to the desert finally after nearly two years of trying. Most stuff is from locally. A friend has three ranches he lets me hunt on. The gold is hard to find....I'm just happy just to get away for the day and try and find anything to be honest. The parks are good to me sometimes. Looking forward to beaches and tops of the Sierras this Summer.. And hooking up with some of you!
Happy hunting fellas..
By Steve Herschbach
Interesting. This new Youtube channel popped up recently for somebody calling themselves X Coils
It appears to be Russian? and they appear to be working on coils for the GPZ. Here is a peek at the 12" x 10". Personally, that's a bit too similar to the stock coil to interest me - I would rather see a 10" x 8". Still, it's interesting that somebody has managed to make some coils that might work on the GPZ without blowing it up. This is one detector that I will have to let others gamble with first on this sort of thing but I knew you would all find it interesting.
They also are showing a 16" round coil....
Hi guys, I ventured out for the day after watching the America's Cup yacht racing early in the morning our time so still had a good amount of the day ahead of me. Got to my spot which was old turned over dry gully workings high up in the hills. I have been down this gully a couple of times with the Zed before, but each time conditions have been different. Dry sunny & long lush grass growth....not too good for detecting, Dry sunny & grass growth non existent. Perfect detecting conditions except for heat & flys. Today was overcast, chilly but the ground was damp from snow fall last week but that had melted off except for way up top. So I was hoping the dampness would aid in better conductivity for deeper targets that had alluded me in the past. Trouble was the grass growth, although dying off was quite long. Should have taken the brush cutter.
You will see the humps & hollows from the old timers turning this gully over. My wagon parked up the back. Had a bit of fun getting through to this gully as the shaded sides of other gullies I had to negotiate to get here were still frozen with a bit of permafrost.
I have in the past found gold all up & down this gully. Both out of the old boys workings & turned over ground but also up on the hill sides out of the workings. Trying to find a run or lead but no joy. Just random deposits The most consistent being the gully floor the old timers turned over. Were I am parked is opposite one of the spots up on the hill side where I came across a wee patch. So I started there with the Zed. I actually started a bit further afield working my way towards the wee patch area hoping to stumble on to some thing. No luck there. Been there done that before but with the damp conditions you never know. I got to the wee patch area & really slowed down. Got a faint little hit.
The ground was gorgeous to dig. Couple of scrapes & the target had moved. Bugger....wasn't going to be of any decent size. Story of my life. Could still be a shot gun pellet yet.
But it wasn't. YE HA But look at the size of it......
I managed one more small piece with the Zed in this area but that was it for the Zed.
So I brought out the Gold Monster thinking there could be some smaller surface to near surface dwellers that the Zed wasnt zoning in on. I left the GM 1000 in Deep All Metal Mode & sensitivity on manual 10 not knowing how this would handle the damp ground conditions. It was manageable but it was a bit more touchy than if the ground were dry. I just had to be a lot more careful with my coil sweep & placement. There was a bit more falsing signals than I usually get running in 10 on the manual sensitivity but I remained in 10 to have that hot edge & an actual signal was an unmistakable hit over the falsing signals. I was rewarded.
But that too was the only bit I could wrangle out of this old patch area. So I moved on. The grass wasn't helping my cause, especially in the gully floor. I went back to the Zed battling through the grass. The grass itself wasn't too bad. It folded over quite easily with the weight of the Zeds coil without falsing but it was those longer dry stalky bits that were very stiff & wouldnt fold over. I swung the coil up on the side of a turned over pile. It was the face of a pile that I had done well on over the years with different detectors so I went carefully slow. Especially as I had those stalky bits to deal with. I got a very faint hit. Could have been a shoty pellet. You will see an old dig top right & to the right. They were both gold.
As was this one. But again...oh so small.
There isn't much bed rock in these workings but there are a couple of small stretches in the very bottom of the gully. I had found a few bits off to the edge of this bed rock with the Zed in the past. So I was keen to run the GM 1000 over it. Well bugger me.....I got a sweet strong hit. One scrape I was on the bed rock.
Chances of it being a pellet? 50/50 but if you look hard you will see a dot of gold.
If you are struggling to see it. Here you go.
The only other chance of pinging some tiny gold with the GM 1000 was on the bald areas of the dig out piles. I say tiny because I have thrashed these from back in my GP 3000 days & small coiltek 10x5 joey mono coils. & the 4500 & NF 8x6 sadie. With good results. You will see a bit of past activity on that mound in the front. You may struggle to see it but center right you will see the Gold monster. I had got a faint signal on a mound back there.
Couple of scrapes & it had moved.
And it wasn't lead.
It had been a long day, the sun was going down & temperature was dropping & the ground would be starting to freeze on the shaded sides & I had a few gullies to negotiate to get to the safety of the ribbon of tar-seal that would take me home.
All up 3 bits for the Zed,on the left, & 3 for the GM 1000 for a total of .5 of a gram The things we do.
Good luck out there