Jump to content
Sign in to follow this  
Tometusns

Equinox " Tells "

Recommended Posts

In the town I live there was a civil war battle/skirmish...depends on who you talk to. It started approx 7 miles north of town that morning crossed over a creek, a branch and a river then thru town before ending up on the SE parts of town at dark. We still have two parks that both had fighting take place in them. We are able to hunt the parks but with that said they are littered with pop tabs, beaver tails,ect. and have been hunted like most parks to death.

 Hunting with an Etrac in the past you got a tell by the ferrous number while looking for lead. We need all the info we can get. What we have discovered with the Equinox is the numbers will jump around on lead...a lot. The pull tabs will lock on solid but the especially smaller roundballs will hit both ways and sound good but the numbers will not lock down. 

My son just got his Equinox 800 yesterday and we did a short hunt in one of the parks. I just got a good hit when he arrived and he was able to listen to it before we dig it and out came a nice round ball. I ended up with 3 more but smaller ones. He called me earlier this evening with his first relic find with the Equinox. Just as before he said numbers all over but good sound both ways and out came a nice round ball. 

I was wondering if you guys had any similar experience with yours. I've dug quite a few round balls so far and you can just about guarantee when you're going to dig lead. 

A tell is a tell to me no matter how it works. Whether the ferrous number is a little lower or the numbers jump.around, I like it. The Equinox definitely has a "tell" for lead. 

Here's some of the lead I've dug the last few hunts in one of the parks. Good luck and HH!

Still pk1 recovery7 iron bias 3 

15645487797843298225312285389797.jpg

  • Like 5
  • Thanks 1

Share this post


Link to post
Share on other sites

Yes, I have noticed oxidized lead numbers vary depending on swing direction across the target.  Fishing weights lock on pretty solid.  Same with deep small brass.

  • Like 2

Share this post


Link to post
Share on other sites

Here in the middle of Illinois I searched a local beach and also noticed the numbers jump all over the place in side to side and front to back motion.

Not knowing what it was I dug it up! Turned out to be a bullet impact into the sand about a 9mm size.

It was located about 6 inches below the ground but gave a good signal while jumping from a 4 to a 15 in all directions.

I think it may have something to do the the minerals in the ground, but being new to this I just don't know for sure.

  • Like 1

Share this post


Link to post
Share on other sites

I've never hunted the beach so I don't know anything about that. I think you made the right move when it sounded good both ways and you dug it up. Good luck and HH!!

 

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Similar Content

    • By phrunt
      My new T2 arrived this week so I decided I'd take it out for a test run today, I haven't bothered detecting football fields before, it never really crossed my mind to do so especially small town football fields that barely ever get used.  I think the last time I even saw people on this thing was about a year ago and they were riding a horse 🙂
      I guess back in time it was probably a popular place and my results today show this.  This is going to be more of a picture story as the pictures tell 1000 words! 
      I started using the T2 with Mars Tiger coil and within two minutes of arriving I had my first coin, then another, then another..... it was nuts, coins everywhere and very little junk, I was finding nice old coins, possibly one of my oldest in a while too

      Silver 🙂

      1938 British Penny

      The T2 was getting good depth, easily hitting on coins with good ID's, another silver!


      1948 Penny -  Now NZ currency, not British like the older Pennies, we used some British currency until 1967. 
      Prior to 1933 United Kingdom currency was the official legal tender of New Zealand, although Australian coins and notes were also generally accepted.
      The first New Zealand penny was minted in 1940. The penny ran until 1965, when New Zealand stopped minting pre-decimal coins in preparation for decimilisation in 1967.


      I have no idea what this thing is

      This is the football field I was detecting, under the goal posts and along the end of the field had a good collection of coins,  I guess from all the diving with the ball and coins in the players pockets, I don't know much about football, probably the only NZ male who has no clue about the game 🙂

      My oldest find of the day, a British 1912 One Penny

      It was quite deep down but the T2 banged on it real hard with a solid ID.  At this point I decided I'd go home and gear up better as this place obviously has a lot of good old coins.  I was only using my T2 with Carrot and Lesche digging tool which was hard work with all the coins being so deep.    I wanted a bigger coil to cover more ground but there was no way I was going to strap on the 15" Teknetics coil to continue using the T2 as it weighs a tonne.  I opted for the Equinox with it's 15" coil  and almost straight away after turning it on, another coin

      1950 NZ One Penny.  I left the bit of dirt on the coil up the top it came out of, I love when you get the impression of the coin in the soil.

      Another silver, 1934 Shilling

      This is the hole it came from, I always recheck my holes and I'm glad I did, another target in the hole, then another... this was crazy


      3 Silvers in the hole so far, 1934 Shilling, 1934 Shilling and a 1946 Sixpence, I was sure this was it but I did another check and off to the side of the hole, ANOTHER SILVER

      Another 1934 Shilling, 4 silvers in one hole, incredible!   Someone had a bad day.

      1964 Sixpence... the coins just kept coming, all old ones.  No longer are they made of silver in 1964...

      Nice and deep though
      +++++
      My first modern coin, a $2

      But look how deep it was, it was deeper than a lot of far older coins.... weird!

      Another two in one hole, just one cent coins from back when NZ had one cent coins.

      Another coin leaving a cool impression of itself in the soil, just a one cent I think

      It sure a lot of ground to cover, I'll be at this place for weeks... plenty more coins to find I'm sure.  Time to head back to the car, with my coil to the soil.

      Another for the road 🙂 Double sided impression on the soil with this one.  I couldn't possibly put up a photo of every coin find as there were just too many, all in about 3 hours detecting.

      The good stuff

      The bad stuff... not a bad ratio, good stuff far outweighed bad stuff, unusual for me.... I'll be back there tomorrow.... and the next day.... and the next day 🙂
       
    • By calabash digger
      Depth and unmasking...
       
    • By dewcon4414
      Heres one id like to see what others have found.    Today i was playing around on the beach with the Nox.   Havent had much time with it  so i thought id see how the F2 was working.    That got me playing around with disc.    What i noticed in disc ...... as i swung the coil it was knocking out the ferr like it should in disc....... HOWEVER i was getting these -1 and -2 iron blurps occasionally.  I also noticed it knocked out the TID for iron except those digits giving the blurps..... oddly.    Im an AM hunter on the beach.   What i did was ..... turned down the volume to 0 for targets 0 and below.    It seemed to work just like disc...... with two exceptions.   1.. you never got ANY sound from those -1 and -2 targets.   2..... the TID was still reading all the iron targets.    So.......out in the water i went hunting in AM target volume for iron set at 2.   Then id switch and go back...... doing it with disc....... then with iron volume at 0 using AM.   Far less noise from mineral...... but i got the same non-ferr targets just as clear.    I know people have asked if there is a difference between disc iron and turning the volume down to 0.   To me there seems to be some near target ID bleed that can create unwanted noise at that 0 disc point.
    • By Joe D.
      Hello everyone, 
       I'm recently new to the site, and was going through the threads, and can't find the one that talked about Equinox water intrusion! So I'm starting a new one! Several months ago i bought a silicone cover and battery compartment seal combo that seems to prevent the problem! But i can't find it on Ebay again! Hope you all will be more successful in locating this product! Here is a screenshot that i saved, and also a picture of the battery seal in place, and removed! I believe it came from the Ukraine! The cover comes with several silicone ties to secure any openings! So far it's worked well, but i have not dive tested! It would seem to me that the battery compartment is the weak link for water intrusion, other than the obvious wire entry points and caps! But this seals all points covered! Good luck and happy hunting!     Joe D.
       



    • By Ridge Runner
      As said I like both the Sport and the Nox face . The great thing about them as you hunt you can really look at the face of each and know what you have notched out . What makes the Nox even better over the Sport is you can notch out one number at a time .
       Oh I know the Nox has so many fine qualities over the Sport it will never have but like the Nox it has a pretty face .
       I don’t know why but a pretty face always tugs at my heart strings and a detector is no different.
       Chuck

      White's MX Sport Display and Controls

      Minelab Equinox Display & Controls
    • By Smithobx
      I was wondering what a replacement of the control pod will cost if out of warranty. Does anyone know the cost of a 600 and 800 control pod if you buy them outright from Minelab?

×
×
  • Create New...