Jump to content

Problem After Updating Equinox 800 To Version 3


Recommended Posts

Hi everyone ... I recently updated my equinox 800 to version 3. I have gone to the beach to test it ... after trying on several beaches the detector is unstable ... beach mode 1-2 ... the screen always shows -9 (with any sensitivity) I can not remove it ... sometimes a small triangle comes out next to the battery ... these beaches where I have always detected, never any problems ... anyone knows the reason
EDIT:
software version 2.1, false signals continuously, sometimes with bad sound (centimes or garbage) I locate with pinpointer but without targets, unstable detector in and out of water
some reason?

Thank you

regards
IMG_7798.thumb.jpg.0cf353431dff00357346e92a1ed12f2d.jpg
Link to comment
Share on other sites


Odd ... it will be interesting to know how this glitch happened.

What operating system did you use for the update?

Link to comment
Share on other sites

If the factory reset doesn't solve the problem do you have a fellow Nox owner that would let you try his coil?  Thinking maybe you had a coil leak.  Do you read -9 in the other detect modes as well?

Link to comment
Share on other sites

Its been 20 hours since they were online here so the messages have not been read.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...