We do like Steve, wife sold her nox 800 just before 3 years and ordered her new one. Showed up today and she was all excited ,put it together, charged up ready to try it out. Well the on/off switch wouldn't work! She was a little disappointed but Minelab said send it in, so off it went !
So some of you know that my 6000 arrived defective right out of the box and that I sent it back to be replaced the morning after I got it. Well the new replacement arrived yesterday and the detector works as I assume it should. Well, at least it will sound off on a nugget, so I assume it is working properly. I have the 14" DD on to test that out. When I picked up the 11" to pull it out of it's plastic bag, I noticed something odd on the top of the coil. There was a crescent shaped crack in the coil. What in the world is going on with Minelab and their quality control.?!! People spend thousands upon thousands of dollars on their detectors, you would think they would be more strict and precise with their quality control procedures. I sent the 11" coil back to be replaced, this morning at 9 am. It is possible it could have happened in shipping, however the inner box and shipping box were in great condition. No smashed areas anywhere on the boxes. Anyone else want to chime in about their particular Minelab detector defect. If Minelab is reading this, you have alot of people out there spending alot of money on your detectors because they are the best-Hands down, but it seems like since the sdc2300 came out the quality control is going down hill. I understand some defects can get by or crop up over a little bit of use, but this is not good.
Just got a XP ORX with the 9x5 HF coil and the coil battery won't charge. The control battery charged up fine but when i try to charge the coil battery the light on the coil blinks every three seconds like it is charged when it is only 30 % charged. The light never stayed on continually like it says in the manual when i first hooked it up and yes i have it hooked up the right way. Thanks, Jim
Through most of 2020 I detected a large park which had been previously detected but still produced decent old coins for me. In one post I told of a well used path to a small waterfall which confused and frustrated me. The path (approx 150-200 m long) is right next to a creek ('stream' for you New Englanders 😉) and it was likely used for watering cattle in the late 19th and early 20th Century. The path was hard packed gravel and crushed stone, occasionl larger pieces of limestone, with soil filled in between all that aggregate. This path gave thick iron response to the Minelab Equinox and produced almost no coins. (I do remember one Zincoln -- I would.) Back then I tried both the 11" stock DD coil and the 6" DD with similar results. With both coils I recovered shallow (meaning mostly within the first 1" depth) lead bullets as well as brass casings. Most were 22 cal. but a few were larger and those in particular I was able to date at over 100 years old. My conclusion is that this path was used by hunters prior to it becoming part of the park. So in summary, lots of small iron (nails and wire), as many bullets and casings as I cared to recover, but no coins. And the recovered targets were mostly located in the top 1 inch.
Some time after my report, kac suggested returning with the Tesoro Vaquero and 8"x9" stock concentric (the only concentric I have for it presently). He and dogodog recommended setting the threshold to where Zincolns just break up. I found out from the park caretaker that the path is scheduled to be covered over completely with a boardwalk so if I was ever going to return, I better make it quick. A week ago I took his advice as well as kac's and doggo's. But in two hours of hunting with the Vaquero I recovered almost nothing. One lead bullet somehow snuck past the threshold and I think I got an aluminum can base, but specifically no coins and practically no trash either.
I had been committed to using concentric coils only and took my Fisher F75 with its tiny 3"x6" concentric as a backup. Returning the the vehicle I swapped out the detectors and returned for 2 more hours. I only use silencing discrimination (and silencing masking) when I have no choice so I set the F75 up in Default process, 4H (4 tones with nickel zone joining the high conductor coins in the highest tone). Low tone is 0-15 which is nominally the entire iron range. With this detector I decided to dig anything 'interesting', at least at the start. As was the case in 2020 I immeditately started recovering lead bullets and brass casings, all very shallow as before. Two more hours and still no coins. I gave up.
At the far end of this wooded path there is construction of a new paved path in the open area of the park. (I've bitched many times before that I hate these backfilling-party upgrades!) For the last hour of this session I decided to search near that path, also at or close to where I had hunted previously. All the coins found that day (just two clad dimes and two copper Memorials) were found in that last hour with the F75 and its tiny coil. Here are the coins I found that day and the next day (described below):
The next morning I returned to search several dirt piles -- the dirt having been removed ("scraped off") so they could backfill the walkway with crushed stone before paving with asphalt. That 2.5 hour hunt was exclusively with the ML Equinox 800 and 11" coil with my standard park/school coin hunting settings. The dirt piles produced only a clad dime -- what a disappointment. For the last hour I just searched part of the park I had hunted previously. One wheat penny was in the ground up trunk of a recently cut down tree (not surprisingly with damage from the blades of that tool). The other Wheatie was in along a path I'm pretty sure I had detected previously, but was less than 2" deep and thus sounded like a shallow Zincoln. (Lesson to self: Be careful what you mentally reject digging....)
Oh, what's that other thing? Near the end of the first day in a dirt pile I got a signal in the nickel zone of the F75 (25-35 on the 0-99 scale) and thought maybe it was in fact a nickel. Imagine my disappointment when it turned out to be a 10kt gold child's ring weighing 0.43 g. (still about $10 in gold content at today's price). That's my first gold jewelry find since December of 2018. Ignoring the foil and pulltab ranges has its advantages... and its downsides.
Finally, the non-valuable non-ferrous finds over these two days.
The finds along the 'noisy' path to the waterfall (4 hours of the 7.5 hour total) are the lead bullets and brass casings, the aluminum bracket at far upper left corner, the chrome plated strap clamp (off womens clothing?), and the two items right above it -- one a small cap (but not bottle cap) and the other a small gear, possibly from a clock. To the right of those, also found along the wooded path, is heavy gauge copper wire wrapped around a fine gauge copper wire -- something electrical I guess. Everything else was from the rest of the (open) area I hunted over those two days. The tag with printing is religious and not old. Note the interesting toy cannon from a WWI(?) playset. I have no idea what those two embossed mating pieces (pot metal?) to the right of the toy gun are. That rectangle at the lower left is some kind of nametag, etc., not a buckle. Lower far right is a thick amber glass jar piece, probably part of a canning jar. Crown cap is pre-plastic liner era (I seldom find those as they rust away over 50+ years). Upper left is a decorative knob off of a piece of furniture. Finally the upper right -- what this was doing in a pile of scrape-off dirt at a park I have no idea. Here's a picture of a nearly identical piece I found googling:
And some info on the company that made it:
I'd much rather be showing you pictures of early coins, especially silver, and I'm sure you would, too, but the earlybird detectorists got those worms, leaving the decaying insects for me.