Jump to content

GPZ Shaft Wobble Resolution


Recommended Posts

  • 2 weeks later...

Got to make sure those pins stay in place too, mine have already tried to come out a couple of times and my detector is only about 7 mths old, and is used less than most.

Link to comment
Share on other sites

1 minute ago, Sheppo said:

Got to make sure those pins stay in place too, mine have already tried to come out a couple of times and my detector is only about 7 mths old, and is used less than most.

That's very unusual, I found the pin very hard to get out, I ended up using a small phillips screw driver and tapping it with a hammer to get it to slide out.  To get it back in I also tapped them with a hammer as there was no way I was going to be pushing it back in with my fingers.  I wonder if your pin is slightly smaller than it should be.

Link to comment
Share on other sites

4 hours ago, phrunt said:

That's very unusual, I found the pin very hard to get out, I ended up using a small phillips screw driver and tapping it with a hammer to get it to slide out.  To get it back in I also tapped them with a hammer as there was no way I was going to be pushing it back in with my fingers.  I wonder if your pin is slightly smaller than it should be.

I honestly haven’t chased it up, I probably should but it hasn’t caused me any major problems.

  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...