Jump to content

Testing Steve's S-shaft Prototype For Equinox


Recommended Posts

Thanks GB will have to measure it. Worst case scenario I'll just machine one up.

Link to comment
Share on other sites


57 minutes ago, kac said:

Thanks GB will have to measure it. Worst case scenario I'll just machine one up.

kac, I've never built a shaft for a Tesoro machine, but I'd be willing to give it a go if you need me to.  What I would need to know is the diameter of the Tesoro lower rod, and a very accurate measurement of the width of the lower rod (the "clevis" or "head" that fits between the coil ears) WITH washers installed...


Steve

  • Like 1
Link to comment
Share on other sites

I could do that when I get to that point, shouldn't be tough. Other option is I could machine up the connector for the coil end and ship to you.

  • Like 1
Link to comment
Share on other sites

Neat teaser review!

I'm definitely interested in that shaft. I have a possible Etrac coming my way though, so I'll have to make sure that doesn't work for me before I invest heavily in my Equinox. But assuming I do, I'll probably be getting one of Steve's shafts...

  • Like 2
Link to comment
Share on other sites

kac -- either way, I'm glad to help if I can.  

mh9162013 -- same for you -- glad to help you out if you decide you'd like to try one!

Thanks!

Steved

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...