Tesoro 8x9 Concentric Coil Cover

[kac]

Surface is a little rough, have to fiddle with the settings on the printer but dimensionally accurate. Coil cover is semi solid so should be better around undergrowth etc, less hangups.

Printed in PVA, ABS or ASA would be better. If anyone likes I can post a link to the cad file.

Marks on top of my coil is from old glow in the dark duct tape, used to do a bit of hunting at dusk and low like, helped me see where the coil was for digging. Will put new tape on when I get around to it. 🙂

[Joe D.]

   WTG on the new 3-D printer project Kac! Looks like a winner!👍👍