max702 Posted May 7, 2022 Share Posted May 7, 2022 anyone know where to find the stl file of this piece? i went through all the 3d print sites but i didn't find it Link to comment Share on other sites More sharing options...
Guest Dug Posted May 10, 2022 Share Posted May 10, 2022 I’m not sure where to find that exact STl, but I may be able to draw something up for you. Let me know what you want and I’ll try to make a printable file for you. A couple guys chimed in on a 3d print subject I posted a while ago. I’m surprised they haven’t offered up their expertise yet. Link to comment Share on other sites More sharing options...
max702 Posted May 13, 2022 Author Share Posted May 13, 2022 I would need a piece equal to the one in the photo to put on the wl6 pole support then I made a second pole for the sea since the standard one flexes a lot and then I noticed that the sand and salt ruin it a lot then I would need it a support for the sensor equal to the standard one like this then I would say that these stl files could be put in the download section because they are certainly very useful to others in the forum Link to comment Share on other sites More sharing options...
Carolina Posted May 13, 2022 Share Posted May 13, 2022 15 minutes ago, max702 said: I would need a piece equal to the one in the photo to put on the wl6 pole support then I made a second pole for the sea since the standard one flexes a lot and then I noticed that the sand and salt ruin it a lot then I would need it a support for the sensor equal to the standard one like this then I would say that these stl files could be put in the download section because they are certainly very useful to others in the forum That piece is the wave. I ordered another antenna for my second shaft and it came with it. If memory serves me $33. Link to comment Share on other sites More sharing options...
max702 Posted May 13, 2022 Author Share Posted May 13, 2022 I made the antenna for the second mast using a shielded cable for wi-fi antennas and the caps on the plate are the stl and it came out a great job at 0 cost considering that the cable used is much softer than the one supplied from xp 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now