Remote Control Support Stl File

[max702]

anyone know where to find the stl file of this piece?

i went through all the 3d print sites but i didn't find it

[Guest Dug]

I’m not sure where to find that exact STl, but I may be able to draw something up for you. Let me know what you want and I’ll try to make a printable file for you. 
 

A couple guys chimed in on a 3d print subject I posted a while ago. I’m surprised they haven’t offered up their expertise yet. 

[max702]

I would need a piece equal to the one in the photo to put on the wl6 pole support then I made a second pole for the sea since the standard one flexes a lot and then I noticed that the sand and salt ruin it a lot then I would need it a support for the sensor equal to the standard one like this then I would say that these stl files could be put in the download section because they are certainly very useful to others in the forum

[Carolina]

15 minutes ago, max702 said:

I would need a piece equal to the one in the photo to put on the wl6 pole support then I made a second pole for the sea since the standard one flexes a lot and then I noticed that the sand and salt ruin it a lot then I would need it a support for the sensor equal to the standard one like this then I would say that these stl files could be put in the download section because they are certainly very useful to others in the forum

That piece is the wave. I ordered another antenna for my second shaft and it came with it. If memory serves me $33.

[max702]

I made the antenna for the second mast using a shielded cable for wi-fi antennas and the caps on the plate are the stl and it came out a great job at 0 cost considering that the cable used is much softer than the one supplied from xp