bklein Posted December 28, 2022 Share Posted December 28, 2022 Turned it on and All Metal mode was dead, Tone mode works, 12.5” coil. Tried8” coil and it works on both. Will show video later. Looked at connector pins and see some loose ones. Is this ok? Link to comment Share on other sites More sharing options...
Carolina Posted December 28, 2022 Share Posted December 28, 2022 Only 2 of the three are used. One will be loose. Measure the coil with a ohm meter. Has nothing to do with the modes. If one works they all work. 3 Link to comment Share on other sites More sharing options...
bklein Posted December 29, 2022 Author Share Posted December 29, 2022 I would think there would be a positive, negative, and shield. The shield would contact the ground somewhere but if not attached to the loose pin it would allow more EMI. Preliminary ohmmeter tests were ok both coils. Link to comment Share on other sites More sharing options...
Carolina Posted December 29, 2022 Share Posted December 29, 2022 7 hours ago, bklein said: I would think there would be a positive, negative, and shield. The shield would contact the ground somewhere but if not attached to the loose pin it would allow more EMI. Preliminary ohmmeter tests were ok both coils. The shield is connected to the neg. in the connector. Only 2 pins used. 1 Link to comment Share on other sites More sharing options...
bklein Posted December 29, 2022 Author Share Posted December 29, 2022 I took off the rear of the connector and maybe it was put on too tight and caused a compression short? That and I sprayed the pins with Dr-Oxit. Works now. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now