Jump to content

AQ Impulse All Metal Mode Died


Recommended Posts


Only 2 of the three are used. One will be loose. Measure the coil with a ohm meter. Has nothing to do with the modes. If one works they all work.

  • Like 3
Link to comment
Share on other sites

I would think there would be a positive, negative, and shield. The shield would contact the ground somewhere but if not attached to the loose pin it would allow more EMI.  Preliminary ohmmeter tests were ok both coils.

Link to comment
Share on other sites

7 hours ago, bklein said:

I would think there would be a positive, negative, and shield. The shield would contact the ground somewhere but if not attached to the loose pin it would allow more EMI.  Preliminary ohmmeter tests were ok both coils.

The shield is connected to the neg. in the connector. Only 2 pins used.

  • Like 1
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...