Jump to content

Deus 2 Coin Hunt High Mineralization


Recommended Posts

51 minutes ago, Valens Legacy said:

Nice hunt with a good ratio of coins to pull tabs.

Good luck on your next hunt.

The pull tabs were dug because they were possible gold jewelry targets. Using Deus 2 with its target ID spread in the low to mid nonferrous range, there is very little overlap of pull tabs and US nickels unless the tabs are damaged. 聽I knew those 21 nickels were either nickels or gold jewelry. Same with the pull tabs.聽

  • Like 5
Link to comment
Share on other sites


Dang, Jeff, you really spanked that hunt, congrats! and well done!

Wow Emoji-100.jpg

Plus 1 on the Tek-Point/F-Pulse. I've started carry my F-Pulse again with the MI-6 and use it to hit those really deep targets that are just beyond the reach of the MI-6.

  • Like 2
Link to comment
Share on other sites

1 hour ago, CPT_GhostLight said:

Dang, Jeff, you really spanked that hunt, congrats! and well done!

Wow Emoji-100.jpg

Plus 1 on the Tek-Point/F-Pulse. I've started carry my F-Pulse again with the MI-6 and use it to hit those really deep targets that are just beyond the reach of the MI-6.

This interests me, but maybe it's a mineralization thing. 馃 I have an F-Pulse now, and haven't found it to be any more useful than the MI-6. I do run the MI-6 at full sensitivity however, and find it detects targets far deeper and more accurately. Guess I'll add it to my bag for Culpeper next week. 馃檪

  • Like 2
Link to comment
Share on other sites

All I have to say is that you are very handy with a screw driver..I don't know if I can dig out 聽9" deep coin with a probe or screw driver. 3-4 inches no problem...nice shooting there Jeff

strick

  • Like 2
Link to comment
Share on other sites

2 hours ago, strick said:

All I have to say is that you are very handy with a screw driver..I don't know if I can dig out 聽9" deep coin with a probe or screw driver. 3-4 inches no problem...nice shooting there Jeff

strick

That would be x 2. HH jim tn

  • Like 1
Link to comment
Share on other sites

On 3/19/2023 at 11:12 AM, F350Platinum said:

This interests me, but maybe it's a mineralization thing. 馃 I have an F-Pulse now, and haven't found it to be any more useful than the MI-6. I do run the MI-6 at full sensitivity however, and find it detects targets far deeper and more accurately. Guess I'll add it to my bag for Culpeper next week. 馃檪

It must be a mineralization thing. Keep in mind, this is hunting in a park situation where I can't dig plugs and have to pinpoint from the surface. I run my MI-6 at 49 on the D2 and the F-Pulse will usually go about an inch or so deeper and if I "super tune" it, it will go an easy 3-4 inches deeper. But in a relic hunt situation where I can dig with a shovel, I don't need to use the F-Pulse.

  • Like 1
Link to comment
Share on other sites

PI pinpointers do not go deeper than IB pinpointers in mild ground. They simply lose depth at a far smaller rate as ground mineralization increases. The worse the ground, the better the PI unit will look relative to the IB models.

09102E9A-1E6D-438E-ACB3-CDD5C5BA615E.jpeg

  • Like 6
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...