Jump to content

X35 Coil Sabatoged


Recommended Posts

I figured it was time to change the battery for my X--35 9" coil, I watched all the videos on how to do it , I figured it would be a cinch,  but after i got the little plastic plate off the bottom of the coil a hard piece of foam was glued in so hard over the little battery connector I could hardly get it out , then i looked to find the connector  to unplug the old battery  and could not even see it , It was totally covered in epoxy glue I pulled on the wire and it broke off, apparently the temp worker filled it with glue and completely covered the battery plug in making it impossible to remove,  why me ? why does it work for everyone else but when i go to do it  its covered in glue, ? I was pissed now it will cost me 300.00$ to get the HF coil . I will never buy another X-35 because I have no assurance the battery plug will not be glued over again .  at least the HF coil its possible to change the battery

  • Sad 1
  • Oh my! 1
Link to comment
Share on other sites


On 3/23/2023 at 7:05 PM, Kaolin washer said:

I figured it was time to change the battery for my X--35 9" coil, I watched all the videos on how to do it , I figured it would be a cinch,  but after i got the little plastic plate off the bottom of the coil a hard piece of foam was glued in so hard over the little battery connector I could hardly get it out , then i looked to find the connector  to unplug the old battery  and could not even see it , It was totally covered in epoxy glue I pulled on the wire and it broke off, apparently the temp worker filled it with glue and completely covered the battery plug in making it impossible to remove,  why me ? why does it work for everyone else but when i go to do it  its covered in glue, ? I was pissed now it will cost me 300.00$ to get the HF coil . I will never buy another X-35 because I have no assurance the battery plug will not be glued over again .  at least the HF coil its possible to change the battery

 Post a picture... I owned USdronerepair for years and fixed hundreds of PCB's and electrical wiring issues. I can guide you through the repair.

Link to comment
Share on other sites

Would have cost all of $30 and perhaps additional shipping one way to send it in to the repair center to have the battery replacement done and even after you broke it, they probably would have repaired your damage too for little if any additional cost.  You cost yourself the $300+ replacement by getting frustrated and throwing it away. SMH.

  • Like 4
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...