Jump to content

Surprise. Park 1 Is Single Frequency


Recommended Posts

I hooked up a sensor coil to pick up the transmit frequencies from my 800. Connected to an audio spectrum analyzer I could see what was being transmitted in all the modes. Surprise, Park 1 uses only a single frequency ~ 15KHz. The amplitudes shown are relative. 

Park.jpg

beach.jpg

Field.jpg

Gold.jpg

  • Like 1
Link to comment
Share on other sites


Program ... Park1 really works in the multi-frequency mode:

I have no doubt about it....

 

DS1Z_QuickPrint119.jpg

  • Like 2
Link to comment
Share on other sites

Indeed, I was just starting to attempt to measure the output from my 800. The analyzer I was using didn't go up to 40KHz, which negated the validity of the test in the first place. The 800 was also in 15KHz mode, therefore the 1 freq. on Park 1. I thought I'd publish this as an April 1st measurement as I figured it might freak some out ?

Anyway, I did get a reasonable test configuration setup and measured the transmit field. In Multi-IQ, it does put out multiple frequencies in ALL modes. Obviously, the magic and "weighting" takes place in the SW of the receiver.

The graph included is the output for all the detecting modes.

 

 

Equ-800-transmit.jpg

  • Like 2
Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...