PPP

I think the same.Have seen all of his videos and he seems to be a very nice guy with honest testing everything.I thing as well that he is a very good candidate to test an AQ!!!

Greate! would'nt be awsome if LE.JAG instead could upload some hunting videos with the AQ? 😐

I want to see a head to head comparrison between ATX and TDIBH. There is no video out there.Can anyone make a video about this?? ATX mono coil VS TDIBH

Hi Guys! When i bought my ATX i bought a Grey Ghost amphibian as well.Fist day in the saltwater after an hour i notice an strange rosty colour spreading all over the back of the detector where the speaker is located.I just got panicked and cancled the hunt immidiately.When i got home i noticed the round edge of the speaker which is metal is rosted as hell!!! I looked around and could'nt find the problem.When i unplugged the headphones i realised that in the Grey ghost package there is some o-rings that i supposed to put it myself on the connector.THAT was the problem!!! i put the o-ring on and problem solved.But my speaker was så rusty i put some silicone glue all over it to isolate it from saltwater.I should send it to Garret which i did'nt. It works ok since then but i think there has been a slightly current without the o-ring that makes the speaker rust.What do you tink guys?

HI guys! It feels very good that this nice forum is at high speed with all discussions about the AQ with all different subjects about the AQ.We are now in the middle of january and still nothing from the Fisher.No reports from any tester, no videos, no manual, nada...it feels kind of depressing without knowing any informations at all.I know that LE.JAG and Alexander can't say anything about these informations even though the know for sure.Is there any thought or any guesses about these questions?

Beach 1 and NO ground balancing, NO disc and run all metal.If you get chatter then put it in beach 2,you loos a little bit of depth in beach 2 but it calms the Nox when you come across a mineralized area.

Its hard to believe that TDIBH beat the ATX in depth.Do you mean by ATX large coil 12inch coil or the big deepseeker? i have both and used both in wet sand and in saltwater.The big deepseeker(20x15 i think) is constantly overload in the water and you have to push the reset button all the time to calm it down.I have seen a lot of TDIBH videos, but didnt see deep targets recovered with it.Unfortunatly there isnt any comparisson video regarding TDIBH vs ATX

I think the Garrett ATX challenges the AQ most and maybe TDIBH come close after ATX only in raw depth.I have myself an ATX and hunt my beach with it. Max sensitivity givs me around 15 inches for a normal coin size object.My Garrett sea hunter is absolutly no match and even my Equinox has no chance.The fair comparisson is ATX (PI , almost same coil size,waterproof ) I think the AQ has only one tone for both high and low conductive targets and one for iron.The ATX has one tone for high and one tone for low conductive targets but you have no tone for iron which makes one to digg all.

I am a design engineer. Spontaneously I can say it is a good and robust design to attach the coil to the shaft.There is no point of failur in the design itself but as OBN says the game changes when you work in saltwater and sand for an amount of time.I am more concern about the thickness of the coil(it is thick!!) and drag resistance in the water.Is there any coil cover? I hav'nt seen benethe the coil if the epoxy is exposed or if its covered.any idea?

This video has been around for awhile.Thanks anyway for sharing

WOOW,finally saw a video of AQ in action!! awsome depth on targets.I guess it must be LE.JAG because he has the same sand scoop.I can't see any control unit or?Thanks for sharing!!!

HI Guys! I pull out deep targets with my Garrett ATX on the beach. i managed to get about 14-15 inches on targets, but after digging almost 15 inches down which takes out all my energy it turns out to be big chunck of iron,because ATX can't tell if its iron at that depth.The question is if the AQ can tell if that deep target is iron chunck so I dont have to digg unnecesseray? I know i should digg out all targets on the beach but at that depth all the time is almost impossible.

HI Rick! Is there going to be an unboxing video we still waiting for?Thanks!!!

I have'nt figuered out what the difference is between tone-mode and all-metall.I think in tone mode you activate the disc to not hear the high conductive targets,or? In mute-mode iron signal is shut down,in all-metall it is a straight PI.A bit confused

Impressive Alexandre! I assume the All-metall mode been used because of that amout of bottlecaps and pile of iron pieces? Could you foud all those gold with the Mute mode? not hearing the iron and just digging gold? In my area there is a lot of big and small piece of metall chunks in the water together with good targets.With my Equinox i faild to find gold in these areas,just pull out some coins.How Impuse AQ performs in these areas? Can it pull out gold rings amongst so many iron chunks i have here? Thanks a lot if you can answer these questions?

woow, Thanks Rick! The control unit with that black appearence is awsome.so much nicer than the blue one.I like the straight shaft as well.Looking forward to the unboxing video!! cheers

Hi Rick! Thanks for all that info..Looking forward for the unboxing video.Just wonder where are you going to put the video for us to watch? Can you give us some words about the balance of the machine, because it has the s-shape shaft which is not so good as everybody knows compare to straight shaft. I have some beaches where i live that has a lot of big iron pieces scattered all over in the water and i know it masks some gold rings definitely. I have tried the Equinox to work between irons to find gold but failed. I don't even dare to go near these areas with my PI machines. The question is if the AQ can pull out gold rings amongst these big iron chunks i have here?? Thanks

LE.JAG could you please give us the latest update on AQ? Last you said its in production.I have a mail from the Fisher saying that there is still no announcement. Give us GOOD news please!!!!! Thanks

HI Guys! I have talked to our dealer in Sweden about the pre-ordering the Impulse.He sent an e-mail to fisher and asked them about the Impulse and they answered that it is not yet available and no price is set.He showed me the e-mail yesterday.Another guy in France put a link in the facebook to a dealer in France who sell or pre-order the Impulse.How thats possible?🤔

Here in Sweden in the winter it is impossible to detect on the wet sand, it becomes like a concrete and the only place that is detectable is in the icy-cold salt water.Almost all fresh drop items from summer is deep and out of the range of VLF detectors like Equinox.Only PI can find those items.Fisher Impulse cant work on the wet sand here right now and you can take it in the water but very shallow maybe.

WooW,, what a relief!! have been waited for this detector for years now.I have already send a message to our metal detector dealer here in Sweden and waiting for the respons.I dont know if the dealer is aware of this detector at all or maybe he is.The price is acceptable if the detector deliver what it suppose to do which is finding gold,then the machine paying itself in no time.