Veisal

Let's touch it a little and that's it

the-legend-brochure-en.pdf

17 hours ago, GB_Amateur said:

Clever, but what does it weigh (with the fasteners, of course)?  Also how much does it change the effective max/min shaft length (and in which direction)?

As data I can't say anything, it's not there yet, but when I receive it I will take pictures with more photos and I will share information with you

Equinox stick

19 minutes ago, Chase Goldman said:

И така... това уникален домашен дизайн ли е и/или нещо, което може да бъде закупено? Достъпни ли са някъде за изтегляне изходните файлове за дизайн на 3D принтер? Не се притеснявайте и просто ни оставете да висим с вашите тийзър снимки и усмихнати емоджита на слънчеви очила.

I considered yes, should I post a link to this product, but if you have questions you can contact the person who designed it

Equinox stick

21 minutes ago, mh9162013 said:

Does that use parts from the stock Equinox shaft?

Nothing is removed from the standard equinox shaft, just the connection of the two rods of the shaft is this

15 hours ago, Steve Herschbach said:

I prefer S rods on machines under 4 lbs. straight shafts in machines over 4 lbs. Long story short it’s the rod design as much as anything that tips the scales for me, and has me going XP instead of NM. Sometimes it’s the simple things that make the difference.

Here are some improvements to the ergonomics of the minelab equinox 600/800 made with a 3D printer 

Hi Steve Herschbach, I have a question about what threshold level you use on the EQUINOX 800, there are instructions in the manual explained neither strongly nor weakly, but in any case at a signal the tone of the threshold is interrupted. My question is how important is the threshold for you?
thank you in advance

For gold mode 1-2:

Frequency: Multi
Ground Balance: Automatic (ground pump method with manual adjustment)
Sensitivity: 16 - 25
Recovery rate 800: 4 - 6 (default is 6)
Recovery rate 600: 2 - 3 (default is 3)
Iron Bias: 0
Accept / Reject: Everything is accepted, count on tones (alternative rejection -9, -8 and -7 if there is too much feedback from the ground)
Threshold level: ...?

Equinox 800, Old Thracian pottery is giving GB in the range of 40-50

29 minutes ago, Steve Herschbach said:

A wide open Equinox, no numbers discriminated, will typically give ground feedback in the low id range of -9, -8 , -7. The worse the ground is, the larger this range gets, so maybe -9, -8 , -7, -6, -5, and -4 need to be blocked in a certain area to eliminate ground chatter.

Yes, it was in this area that my question was, thank you for the quick and comprehensive answer

Hello everyone, maybe some information about orientation in minelab equinox 800, I searched a lot, but I can't find such information.
I am looking for information on minelab equinox 800 in the ground balance how we can orient ourselves in the numbers for setting the ground in the ground balance, on the equinox 800 the numbers are from - 9 to +100 how to find out how much our land is ore.
On some brands of metal detectors soil balance is from 0 to 100 and 100 is the most degraded land ?

And is it possible for minelab to offer a new upgrade of the minelab software Equinox 800 

Here is the miracle 

https://www.youtube.com/watch?v=27N9_3h4ZDk

Hello, thank you all for the warm welcome.
The place where I look for native gold is this as rock geology is this, I searched for about 2 hours but found nothing, I will try again for more time searching in the same region ?

Hello everyone and from me, a new member of the forum new in the search for native gold with a metal detector.
My first metal detector is Minelab EQUINOX 800 with 11-inch and 6-inch coil
A little about me: My name is Veisal, I am 35 years old, I am from Bulgaria, a country located in Europe

Hello, have a question: why are you in gold mode 1 settings instead of gold mode 2?

Gold mode 1
Frequency: Multi-terrestrial
balancing: Automatic (ground pump method)
Sensitivity: 18 - 23
Recovery rate: 4 - 6
Iron bias: 0
Acceptance / rejection: -9 to -7 rejected, -6 to 40 accepted

Hello everyone and from me, a new member of the forum new in the search for native gold with a metal detector.
My first metal detector is Minelab EQUINOX 800 with 11-inch and 6-inch coil
A little about me: My name is Veisal, I am 35 years old, I am from Bulgaria, a country located in Europe