Jerseybones

Might be a dumb question but, when using the WS6 master can another WS6 be paired for headphones? Thx K

Have been using the doo dads clip on my D2, so fa so good 👍

Hi Steve, it was just intended for someone that already has an ATX.

Not as handy for working controls but worth it for me, having a really bad wrist problem.

Yep, ran an extension of straight cable through a fixed carbon shaft( similar to Excal straight shaft mods) into a waist mounted pack for controls. So much lighter. Reversible if necessary just cut out the splice and reattach connector. Hope this helps.

Hi Luca , have done various mods to the ATX . To do one for your intended configuration. Dismantle stem on coil down to last section. Remove connector from cable. Splice appropriate diameter and length of straight shielded cable long enough to reach your pack an also lay down when you are down on the ground. A waterproof splice can be done by degreasing cable jacket in splice area slipping a short section of some sort of tubing over splice area and then potting with an appropriate compound . Reconnect cable end and connect to control box passing through a handle of of your own design ie- I used a piece of carbon fiber tubing same inner diameter as o.d. Of coil stem.and made a handle and cuff from my parts pile. You could alternately make a handle that worked with the existing shaft by using a piece of tubing that fits into the existing collapsible shaft and working up a handle from that platform I just didn’t because I already had parts laying around. Hope this inspires you to build. Post pics when you finish. Have fun

Consider myself pretty handy, a question for anyone. I would like to repair an ATX 12in dd with the typical cracked up coil wire, looking for info on replacement coiled wire and a new connector plug . If none are available then what would be the proper straight cable to use to connect it without the capability to retract it? Just for a “see if I can fix it” project. Thx for any info, Jerseybones