Jump to content

Trueman

Full Member
  • Posts

    2
  • Joined

  • Last visited

Profile Information

  • Gender
    Male
  • Location:
    Czechia
  • Interests:
    Gold prospecting, relic huntig
  • Gear In Use:
    Garrett atx

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Trueman's Achievements

Contributor

Contributor (2/6)

2

Reputation

  1. Hi Steve, thank you for your extensive answer. I give myself some time to read and think about what is written in articles you so kindely share with me. I came across an artice about how is done Gbpi detector with no detection hole. There was written article about pairs of frequencies that reapet in order to exclude the detection hole. Each of these frequencies must be different from the other one, it make sense to me. But I want to ask you. It is the defference between them only in khz or is it something else?
  2. Hi friends from US! While doing my deep research on atx, to really understand how this technology works. I struggled to identificaing targets based on audio tones. Yes, I know that Pi machine has poor ability for recognition targets. But while motion mode provides dual tone audio feedback, I keep wondering about message that provides me. That scale of tones may varying from hi/low to low/hi and that is my question. If tone starts with very short low tone with long hi tone echo, what I can predict about target material? And otherwise. If target get you short hi tone followed by long low echo, may I assume that the long echo tone assigning the target to the scale of material corresponding to the tone? So if I get short low tone followed by long hi echo, target response should be somewhere close to low conductive material? Even if the complete audio response is low/hi indicating good conductor? Is there any advice how I can be better in recognition targets based only on audio response, beside to dig everything what Iron check doesnt recognize? How the iron check actually works? Can I use it to helping identificaing targets, even if they are not iron. I have noticed that if I swing over for example pulltab in Iron check mode, it does not make any difference(off course it did not), but when the audio is non existent in Iron check, what that can tell me? Before You ask why I decide for atx ( If you dont know Iam a begginer) I am also motorcycle enthusiastic and my condition for packing are limited, so this is numero uno for me, and offcourse the military housing just ring a bell for me. Thank you for your time. Greetings René
×
×
  • Create New...