中国 张 Posted September 12 Share Posted September 12 AlgoForce E-1500 8*6 MK2 Coil, is it available in the Australian market? Link to comment Share on other sites More sharing options...
phrunt Posted September 12 Share Posted September 12 Yes, you can buy it now in Australia, reports are it's a good coil on the Algoforce, much better than the original, more sensitive too. 2 Link to comment Share on other sites More sharing options...
PhaseTech Posted September 15 Share Posted September 15 On 9/13/2024 at 4:27 AM, phrunt said: Yes, you can buy it now in Australia, reports are it's a good coil on the Algoforce, much better than the original, more sensitive too. Technically released, but not available. First batch would have sold out everywhere. 3 Link to comment Share on other sites More sharing options...
phrunt Posted September 15 Share Posted September 15 5 minutes ago, PhaseTech said: Technically released, but not available. First batch would have sold out everywhere. Have you had a chance to try one out, I'd certainly value your opinion. I'd only just bought the original Sadie and a week or two later the new ones start doing the rounds on social media, I had no idea the old one was being replaced at the time or I wouldn't have purchased the old one, now I'm in a conundrum about buying the new one too. Link to comment Share on other sites More sharing options...
PhaseTech Posted September 15 Share Posted September 15 Don't think I'll get to have a play with one until I satisfy customer backorders. So depends on how many I get in the next batch. 1 Link to comment Share on other sites More sharing options...
Tony Posted September 16 Share Posted September 16 Is the new version Sadie Mk2 still bundle wound. My GP3500 prefers not to be run on spiral/flat coils....she gets a bit cranky. Link to comment Share on other sites More sharing options...
PhaseTech Posted September 17 Share Posted September 17 Definitely not a spiral as it physically can't fit in an 8x6. 1 1 Link to comment Share on other sites More sharing options...
Aureous Posted September 17 Share Posted September 17 Just a feeling, based on a couple hints told to me, the Mk2 Sadie might be block-wound, like the Exceed coil for the 6000, you may notice that the shell design shows the Y axis extra thickness, like the Exceed. A square former is inside the coil shell and layers of litz wire are embedded into the former (like a flat wind) op top of each other, to form a square or rectangle bundle, instead of a circular one. It gives some benefits of a flat wind, without the over-use of space within the shell. Also provides low noise, like the Exceed coil demonstrates. Older legacy Minelab PI's might not like it, best test before you buy. 5 Link to comment Share on other sites More sharing options...
phrunt Posted September 17 Share Posted September 17 that would explain the extra sensitivity, manufacturers really latched onto this one they saw it done. 1 Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now