Jump to content

Recommended Posts

No explanation needed. This video by Gary Blackwell is priceless.

 

  • Like 8
  • Thanks 1

On 1/18/2025 at 12:47 AM, Jeff McClendon said:

No explanation needed.

Interesting comment on how he perceives the electronics gets cluttered/overloaded. I notice this on a daily event when hitting many ferrous targets, heavier black sand with higher sensitivity or strong wave wash. A very good explanation by him. 

  • Like 1
  • 2 weeks later...
On 1/20/2025 at 1:33 PM, midalake said:

Interesting comment on how he perceives the electronics gets cluttered/overloaded

Now routinely performing a “factory reset” at each start up with an updated EQX 900. After a frequency scan & ground balance only minor site specific adjustments to sensitivity, recovery & iron bias, if needed. So simple it works. 

  • Like 1

The only times I did Equinox factory resets was when I updated software, changed coils or when my Equinox had not been turned on in a while. Same with Manticore. 

  • Like 1
9 minutes ago, Jeff McClendon said:

The only times I did Equinox factory resets was when

The reset is more for me than the detector. At first I played with every setting combo but the truth is in the end a rake and a larger magnet delivered me back to the basics. A lot of layered iron trash and rust halos to scrape through but every once in a while a good target pops out.  There has to be an old belt buckle down there somewhere. 

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...