castleberry

Hi Jeff and phrunt Thanks for the replies and time.. Yes its a bran new few day old 600 and test garden...Good to verify that Im on the right track and things are working as they should. Brian

Hello, New beginner from Middle TN with a new Equinox 600. Great forum here and I have read and digested to my best ability all the good information here. I have my 600 factory reset and in Park1. Have my test bed setup with a assortment of clad, sliver, copper, zinc, lead, iron and shredded aluminum, All at around 6-7 inches, but I did put a silver dime at 10 inches ( its flat, not not on edge). Im getting super results on everything but the 10 inch dime. I see lots of videos where this should not be a issue. Again, factory defaults, park 1, noise cancelled while held up in air, default ground balance, sensitivity 20.. Not a peep on the 10in dime.. If I crank up the sensitivity to 25 I do start to get peeps , but not consistent... Thoughts on what I should try and if this is to be expected or if I may have a bad unit... or any pointers at all would be much appreciated. Best Regards Brian