Securing Your Coil Cable Question

[DSMITH]

On all my VLF detectors I usually run the coil cable straight up the top of the shaft securing it with Velcro type cable straps, I usually do this all the way up the lower shaft and then wrap the coil cable around the Mid shaft to the control housing, this has always worked for me

my question is, is it ok to do the same thing on a PI like the Axiom or should the coil cable be wrapped all the way up the shaft starting with the first wrap over top of the shaft ???, or is straight up the shaft ok ???

 

in the photo is how I have the coil cable on my Axiom

 

[peterinaust]

When I had my Axiom, I ran the cable much the same as you have.

[All_Metal_Mode]

However the cable is best managed to be out of your way is perfectly fine for a PI. I wish there was a secret wrapping technique to increase the sensitivity or capability of your detector, but the cable is transmit only and usually shielded to prevent EMF noise.