Algoforce Firmware Update 1.08 Now Available For Download

[Taz]

24 minutes ago, phrunt said:

Yes, I would imagine so, you only need to take your control pod, so pop it off and take it along with the supplied USB C to A cable that your battery normally plugs into, you won't need battery as the computer powers it to do the update, plug the USB A end into the library computer, download the flash tool and the firmware and it will be pretty easy for you.  You just run the flash tool, select the firmware file that you download and click the update, my video shows a lot of the process.  It's very easy, as soon as it says it's completed you can disconnect the detector and you're good to go.  

 

Thanks. 

[Nedkelly]

Don't do what I did and forget to hit the power button on the detector after its connected to the computer.   After a couple of hours getting very stressed out I hit the button and bingo , easy as after that. ?

I'm not very computer savvy as you can probably tell. ?

[phrunt]

4 minutes ago, Nedkelly said:

Don't do what I did and forget to hit the power button on the detector after its connected to the computer.   After a couple of hours getting very stressed out I hit the button and bingo , easy as after that. ?

I'm not very computer savvy as you can probably tell. ?

Yes, it always helps to turn something on ?

 

[Nedkelly]

3 minutes ago, phrunt said:

Yes, it always helps to turn something on ?

 

I'm blaming you phrunt LOL ?  After watching your demo vid over and over I didn't see you turn it on. Just kidding my stupid fault. Or maybe  I'll blame the beers.?

[Nedkelly]

Just heard of a new update for the Algoforce, anyone know what the updates will improve and if available yet.

[phrunt]

It's not available yet, won't be too far off, I was fortunate enough to be offered to try it out before release, and it does all it's meant to do well.