nickelNdimed Posted November 2, 2020 Share Posted November 2, 2020 For those that have extra coils, do you just get an extra lower shaft? Or would it make sense to have lower and a middle shaft as well so that length can already be set and you have all of your coil wraps already there? I also thought about a second full shaft and using one of those 3D printed pod quick connects but they don’t seem durable and it adds to the cost of for the extra convenience... Thanks Link to comment Share on other sites More sharing options...
Tom Slick Posted November 2, 2020 Share Posted November 2, 2020 I just get extra lower rods for my extra coils. It only take a few seconds to wrap the extra coil cable around the middle and upper shafts. 2 Link to comment Share on other sites More sharing options...
stevejhgla Posted November 2, 2020 Share Posted November 2, 2020 This is a good idea...I've been unscrewing them when switching from the 11 to the 15. Link to comment Share on other sites More sharing options...
Joel Posted November 3, 2020 Share Posted November 3, 2020 I went with both lower & middle shafts. Since I store the detector with the top shaft separated from the middle one it makes it easy to pick which one I will be using or to switch to another one. 2 Link to comment Share on other sites More sharing options...
nickelNdimed Posted November 3, 2020 Author Share Posted November 3, 2020 Are you just buying the replacement shaft kit that includes the upper or have you found another way to purchase these? The lower is $30 and the whole shaft $45. I’ve only seen them upper separately for $7-8. Link to comment Share on other sites More sharing options...
Joel Posted November 3, 2020 Share Posted November 3, 2020 I bought the coil and lower shaft at the same time and then ordered a middle shaft from Minelab Detector Center in PA for $19.86 + $10 shipping in March 2019. 1 Link to comment Share on other sites More sharing options...
nickelNdimed Posted November 5, 2020 Author Share Posted November 5, 2020 On 11/2/2020 at 8:30 PM, Joel said: I went with both lower & middle shafts. Since I store the detector with the top shaft separated from the middle one it makes it easy to pick which one I will be using or to switch to another one. I like this idea better than just the lower after looking at the detector hanging on wall and swapping the coil a couple of times. Link to comment Share on other sites More sharing options...
relicmeister Posted November 6, 2020 Share Posted November 6, 2020 I’m hoping to have a whole separate equinox 600 so I can have one for the 11” coil and one for the 6” coil. Not hard to find good deals on used machines. Swapping out coils can never be simple enough for me. 1 Link to comment Share on other sites More sharing options...
nickelNdimed Posted November 7, 2020 Author Share Posted November 7, 2020 On 11/6/2020 at 5:30 AM, relicmeister said: I’m hoping to have a whole separate equinox 600 so I can have one for the 11” coil and one for the 6” coil. Not hard to find good deals on used machines. Swapping out coils can never be simple enough for me. I’ve thought about this as well but just seems overkill for my needs. Plus the Equinox still seems to hold its value. If I was really committed to the Equinox only and drove long distances where having a failure might ruin your trip, I would probably go this route and sell my other detectors. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now