fishersari Posted January 16 Share Posted January 16 11 hours ago, okara gold said: a Recovery Speed of '4' creates a electronic symbiotic harmonious quescense balance between electronics VS wet-salt What does this mean? that recovery speed of 4 gives the best overall responses of what's in the ground? Link to comment Share on other sites More sharing options...
TampaBayBrad Posted January 18 Share Posted January 18 On 1/16/2024 at 7:54 AM, fishersari said: What does this mean? that recovery speed of 4 gives the best overall responses of what's in the ground? That's Tom speak for "Leave it at 4". 😄 Link to comment Share on other sites More sharing options...
TampaBayBrad Posted January 18 Share Posted January 18 On 1/15/2024 at 6:03 PM, Suncoast Kid said: I'm about to go to the beach with my M15, starting with Beach Low Conductor, Prospecting audio, iron 4 upper, 0 lower. Iron volume about half the total volume, no discrimination Those are the settings I'm using for the M15 and the 11 also. You should do well with 4 recovery. I dug a crazy deep dime this morning in the same hole as a small rusted screw with the M15. I heard the dime first among the iron grunts and then saw the TIDs bouncing to 80 at the same time I'm hearing iron grunts. I said to myself "There's something else next to that dime." They both came out in the same scoop after I dug deep enough. Link to comment Share on other sites More sharing options...
okara gold Posted January 19 Share Posted January 19 On 1/16/2024 at 7:54 AM, fishersari said: What does this mean? that recovery speed of 4 gives the best overall responses of what's in the ground? Yes... Apparently, Tom is saying that a recovery speed of 4 is the best "marriage" of the Manticores electronics and a wet-salt environment. I have tried switching between a 3 and 4 speed on numerous targets as a test and for me, the recovery speed of 4 is sharper in audio and also lets me run my sensitivity higher. Link to comment Share on other sites More sharing options...
Airtemisa Posted January 22 Share Posted January 22 Another answer on Tom's forum Hello Tom! I was detecting M8, LC on Friday and in very similar conditions to previous days. The beach is still open and continues to produce, although not at the same rate, since we have already removed the most detectable signals. Stable vdi 10 signal, about 30 cm (11" approx), a handmade, artisan ring. I have no idea how old it may be, but it is beautiful. I didn't go below 4 RS and could run 30 sens. Manticore is different. Link to comment Share on other sites More sharing options...
TripleT Posted January 22 Share Posted January 22 Where I fresh water hunt there is a lot of can refuse over the last 100 years. Deep iron is a big problem. Yes, 4 on RS seems to work best with sensitivity between 19 and 21 in LC mode. Being in water helps slow down your swing speed. Ring and coin recovery has picked up with these settings. Link to comment Share on other sites More sharing options...
Camoi Posted March 20 Share Posted March 20 Hello friends. What would be the deepest way to use it in the water, in the surfing area? Does anyone have any setup? remove this used out of the water. obs. salty water. M8 OR M11? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now