Cabin Fever Posted September 22, 2017 Share Posted September 22, 2017 Pretty close. The CTX 11" Pro Coil is very hard to beat. One of the few stock coils you don't feel like you have to replace with an aftermarket coil. Bryan 1 Link to comment Share on other sites More sharing options...
steveg Posted September 23, 2017 Share Posted September 23, 2017 I am really looking forward to some field reports from trusted sources, SPECIFICALLY with regards to how the multi-frequency mode performs in a coin-hunting scenario. This machine looks like it will be "good," and very solid competition with several single-frequency VLF-type units. If that proves to be true -- if it entirely "holds its own" against units like the Deus, etc., then Minelab has done a nice job. But, what would pull me in and make me a buyer is the in-ground performance of the MULTI-FREQUENCY mode. How well this mode performs (depth, and ID accuracy at depth) is what would push this machine, for me, into a class above all other single-frequency units, and thus seal the deal for me in terms of becoming an 800 owner. Can't wait until this real-world, in-the-field information starts coming in... Steve 1 Link to comment Share on other sites More sharing options...
Steve Herschbach Posted October 21, 2017 Author Share Posted October 21, 2017 On 9/23/2017 at 4:23 PM, steveg said: But, what would pull me in and make me a buyer is the in-ground performance of the MULTI-FREQUENCY mode. How well this mode performs (depth, and ID accuracy at depth) is what would push this machine, for me, into a class above all other single-frequency units If this quote from Minelab can be trusted then it sounds like you will get your wish.... ”Multi-IQ achieves a high level of target ID accuracy at depth much better than any single frequency detector can achieve” Since 2014 I have been on a quest to find my perfect all around detector. So far without success, but the Equinox 800 comes closer than anything yet. The next few months are going to be interesting! 4 Link to comment Share on other sites More sharing options...
steveg Posted October 21, 2017 Share Posted October 21, 2017 Yep, I saw that, Steve. It absolutely caught my attention, and piqued my interest. I agree with you that so far, the Equinox looks like it is going to come as close to anything I've seen at competing with my Explorers, and in a much lighter, waterproof, less-expensive package... I'm on a wait list now, as I've been convinced enough to get my hands on one and put it through some testing... :) Steve Link to comment Share on other sites More sharing options...
Ridge Runner Posted October 22, 2017 Share Posted October 22, 2017 steveg I found out long ago it cost just a little more to go first class and that is why I too went with the 800. My trouble now is I find myself each day looking all over the net for any word about the big day we'll get it. The Best Chuck Link to comment Share on other sites More sharing options...
Cabin Fever Posted October 26, 2017 Share Posted October 26, 2017 Found this photo on another forum. The poster said they pulled it off a Facebook page so I don't know if it's legit.. if accurate it gives a little more info on the Equinox.. I feel a little uneasy posting this since it's not verified but here it is.. Just keep the lack of sources in mind. Bryan Link to comment Share on other sites More sharing options...
Ringmoney Posted November 11, 2017 Share Posted November 11, 2017 On 16/09/2017 at 9:14 AM, Steve Herschbach said: Emm, why is there a TID number 46 on the screen??? Link to comment Share on other sites More sharing options...
Steve Herschbach Posted November 11, 2017 Author Share Posted November 11, 2017 Because that is the number the marketing folks stuck in there when they did the studio photo. Somebody was probably told a 50 target id number range meant a high end of 50, when you in actual fact only go to 40 due to 0 to negative 9 occupying the ferrous part of the range. This stuff happens all the time. Almost every screen shot of a White's MX7 on the internet now is wrong except for the couple I posted. A early production mockup photo got passed along and now every sales site out there has it, even though it is wildly different than what a person will get if they order one. Link to comment Share on other sites More sharing options...
57buick Posted November 12, 2017 Share Posted November 12, 2017 It looks like from this last picture you posted Steve that the grip and screen will slide and adjust on the shaft. Which means you could easily adapt this to any similar diameter shaft like the Gold Monster does. Interesting, people will be modding these as soon as they get em lol I am pre ordering one myself. Can't wait to try it out Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now