Jump to content

XP ORX User Guide 11/21/2018


1 Screenshot


  • Similar Content

    • By Rick N. MI
      I buried a 3.7 grams 14k Gold ring at 14" in the sand at a beach on a lake. The ground is mild.
      I went over the sand with 0 disc to make sure it was clean.
      Setting were sensitivity 96, recovery 2 and disc at 7.
      I went over the ring with 3 tone, 4 tone and gold 1.
      3 tone & 4 tone hit it very good. I was surprised 3 tone hit good.
      Gold 1 was a very soft hit.
      All the frequencies 14 khz to 54 khz hit it.
      This spring I'll be hunting in the water with it.

    • By oldcoinhunter
      Been using the Simplex with the SP 24 for a year now and have done really well with it, especially in trashy areas. Just won an xp orx which came with the hf elliptical coil and I just ordered a 9 inch x 35 coil. Detected a couple of places with the orx and it doesn’t seem to separate out the trash that is close to a coin like the Simplex. I’m wondering if the x35 coil I’m getting  can be setup to do as well as the simplex in trashy areas. Thank, Jim
    • By oldcoinhunter
      Looking for some user settings for coins and jewelry in parks and any tweaks in the two gold settings for small nuggets in mineralized ground. Thanks, Jim.
    • By oldcoinhunter
      Just got a XP ORX with the 9x5 HF coil and the coil battery won't charge. The control battery charged up fine but when i try to charge the coil battery the light on the coil blinks every three seconds like it is charged when it is only 30 % charged. The light never stayed on continually like it says in the manual when i first hooked it up and yes i have it hooked up the right way. Thanks, Jim
    • By Rick N. MI
      The battery for the coil is fully charged. I entered the coil number that's on top of the coil in slot 1. I validated it and no connection on the controller. No frequencies. I went thru the process several times and no connection. Any help with this?
      Thanks,
      Rick
×
×
  • Create New...