First Texas Finally Has A New Website

[Jeff McClendon]

1 hour ago, Steve Herschbach said:

When using one washer you are getting a plastic to plastic fit on one side against a thin raised edge where the washer was supposed to go if this had been done right. Those thin edges may wear excessively for people that flip the coil a lot for some reason, so the "use one washer" solution is obviously not ideal and I refuse it was supposed to be that way. But it is what it is. Maybe find or make some thinner washers. I promise complaining about it will fall on deaf ears so just do what you have to do so you can go detecting.

I takes me all of 2 minutes to use a fine grit foam sanding block to custom fit the washers for this situation. Just saying.

[Chacapamac]

Yes, I was a bit de-concerted as I went back to www.fisherlab.com and redirect to the new website —> https://firsttexasproducts.com/pages/allfisher

For people that want to see infos that was on the old website (not all the infos make it to the new website yet) you can go to the Wayback Machine Archive at —> https://web.archive.org/web/20230727112703/http://www.fisherlab.com/

Note: Must but not all links work on the Wayback Archive of www.fisherlab.com

 

Also, I find the the F19 Manual on the NEW website

—> In the F19 page —> https://firsttexasproducts.com/pages/f19

—> click on “English Manual ”

—> https://cdn.shopify.com/s/files/1/0828/6417/7432/files/F19Manual.pdf?v=1697068968

 

Good Day to All!