Jim in Idaho Posted September 11, 2022 Share Posted September 11, 2022 4 hours ago, Geotech said: Yes, lowering the cap values makes the demods faster with a slight loss of depth. I would leave them alone, I'm not even sure why Reg lowered them on the SL as it also tends to be noisier. Ya know, Carl, I haven't seen much increase in noise on mine, after doing the mod. I did see a big difference in allowable swing speed, and yet still see very small targets. I think it was a good mod to do, for me. From the sensitivity I've seen on mine, compared to a lot of the videos I've watched, I think my SL is very good. Besides reg's mods, I've also added vernier controls on both GB, and Threshold...makes tuning really easy, and accurate. Jim Link to comment Share on other sites More sharing options...
kadir6141 Posted January 23 Share Posted January 23 Hi.There are many test points on the whites tdi sl. There is only 1 trimpot on the pcb. There is no information for test points. Can anyone help with this? Link to comment Share on other sites More sharing options...
kadir6141 Posted January 23 Share Posted January 23 I made a 45cm mono coil for TDI SL. inductance 300uh 3.5R. But the distance is the same as the original dual field coil. There is no change in distance. What could be the reason for this or what method should we do? Link to comment Share on other sites More sharing options...
GB_Amateur Posted January 23 Share Posted January 23 56 minutes ago, kadir6141 said: I made a 45cm mono coil for TDI SL. inductance 300uh 3.5R. But the distance is the same as the original dual field coil. There is no change in distance. What could be the reason for this or what method should we do? Is this an air test, and what is your test target? Please give as much information about your test setup as possible. Link to comment Share on other sites More sharing options...
kadir6141 Posted January 23 Share Posted January 23 There is no distance in the air and subsoil depth test. Link to comment Share on other sites More sharing options...
kadir6141 Posted January 23 Share Posted January 23 1 hour ago, GB_Amateur said: Bu bir hava testi mi ve test hedefiniz nedir? Lütfen test kurulumunuz hakkında mümkün olduğunca fazla bilgi verin. There is no distance in the air and subsoil depth test. Link to comment Share on other sites More sharing options...
GB_Amateur Posted January 23 Share Posted January 23 3 hours ago, kadir6141 said: There is no change in distance. What do you mean by 'distance'? Link to comment Share on other sites More sharing options...
Cascade Steven Posted January 24 Share Posted January 24 I have been rereading this thread and have a question about the coarse and fine adjustment system. In regards to the TDI SL, in place of using a vernier to adjust the ground balance, is it technically and mechanically feasible to add a 10K pot in series as the TDI Pro uses? Just curious. Thanks. Link to comment Share on other sites More sharing options...
kadir6141 Posted January 24 Share Posted January 24 18 hours ago, GB_Amateur said: 'Mesafe' derken neyi kastediyorsun? Deep Link to comment Share on other sites More sharing options...
Geotech Posted January 24 Share Posted January 24 10 hours ago, Cascade Steven said: I have been rereading this thread and have a question about the coarse and fine adjustment system. In regards to the TDI SL, in place of using a vernier to adjust the ground balance, is it technically and mechanically feasible to add a 10K pot in series as the TDI Pro uses? Just curious. Thanks. Yes, same thing will work. Try to wire it with coax if you can, for noise reasons. A chopped-up S-video cable works nicely. If not, twist the wires. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now