Jump to content
Sign in to follow this  
Tometusns

Equinox " Tells "

Recommended Posts

In the town I live there was a civil war battle/skirmish...depends on who you talk to. It started approx 7 miles north of town that morning crossed over a creek, a branch and a river then thru town before ending up on the SE parts of town at dark. We still have two parks that both had fighting take place in them. We are able to hunt the parks but with that said they are littered with pop tabs, beaver tails,ect. and have been hunted like most parks to death.

 Hunting with an Etrac in the past you got a tell by the ferrous number while looking for lead. We need all the info we can get. What we have discovered with the Equinox is the numbers will jump around on lead...a lot. The pull tabs will lock on solid but the especially smaller roundballs will hit both ways and sound good but the numbers will not lock down. 

My son just got his Equinox 800 yesterday and we did a short hunt in one of the parks. I just got a good hit when he arrived and he was able to listen to it before we dig it and out came a nice round ball. I ended up with 3 more but smaller ones. He called me earlier this evening with his first relic find with the Equinox. Just as before he said numbers all over but good sound both ways and out came a nice round ball. 

I was wondering if you guys had any similar experience with yours. I've dug quite a few round balls so far and you can just about guarantee when you're going to dig lead. 

A tell is a tell to me no matter how it works. Whether the ferrous number is a little lower or the numbers jump.around, I like it. The Equinox definitely has a "tell" for lead. 

Here's some of the lead I've dug the last few hunts in one of the parks. Good luck and HH!

Still pk1 recovery7 iron bias 3 

15645487797843298225312285389797.jpg

  • Like 5
  • Thanks 1

Share this post


Link to post
Share on other sites

Yes, I have noticed oxidized lead numbers vary depending on swing direction across the target.  Fishing weights lock on pretty solid.  Same with deep small brass.

  • Like 2

Share this post


Link to post
Share on other sites

Here in the middle of Illinois I searched a local beach and also noticed the numbers jump all over the place in side to side and front to back motion.

Not knowing what it was I dug it up! Turned out to be a bullet impact into the sand about a 9mm size.

It was located about 6 inches below the ground but gave a good signal while jumping from a 4 to a 15 in all directions.

I think it may have something to do the the minerals in the ground, but being new to this I just don't know for sure.

  • Like 1

Share this post


Link to post
Share on other sites

I've never hunted the beach so I don't know anything about that. I think you made the right move when it sounded good both ways and you dug it up. Good luck and HH!!

 

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Similar Content

    • By Argyris
      Hi everyone, glad to find this wonderfull forum 🙂 This is my first message here so I'll make my intro with an Equinox 800-newbee question:
      I must state that I have very limited field time and experience with my brand new Nox 800...and only used it in a local beach since now (dry part) to learn it some. But, my first observation is that even in Beach 1 mode (which is a low weighted multi freq mode) I'm getting super tiny targets, usually tiny micro bits of aluminum or lead. I know that for many this is an advantage in order to hit micro gold jewelry and such on the beach...but sometimes it gets really frustrating and time consuming to chase super tiny bits of metal that my PI pinpointer struggles to hit. Trully, I wasn't prepared for such a sensitivity (which is good for the Nox) but isn't always what I need in trashy sites when I'm playing the odds some and focus only in rings or coins.
      So, my understanding based on the above initial beach experience is that, if Beach 1 is so sensitive to tiny staff, then Park 1 (which is also low weighted but not that low weighted as beach 1) should be even more sensitive to tiny micro sized targets. These targets even they are so tiny, they still register VDI >5 cause they usually are micro bits of melted aluminum (nuggets), tiny can slaw or tiny lead, so rejecting 0-5 vdis doesn't get rid of them like it does with small foil.
      Now...I'm asking this having inland hunting in the back of my mind also: when hunting in old farm fields with lots of such aluminum/lead tiny pieces, I was used to run in 8 khz with my old Deus to get rid of such tiny targets and still be able to hit high conductive coins or decent sized hammered coins and other decent sized low conductors, gold/silver jewelry etc. My first Nox experience shows that even if I use park 1 mode in these farm fields, I'll still hit hard on these tiny junk pieces even if i notch 0-5 vdis....so I was thinking to maybe use Park 1 in single freq @5 or 10 khz in such cases, and go after all small or decent size coins & rings, but not the super tiny 1-5 mm diameter junk...My understanding, however, is that with single freq I'll lose the advantage of VDI stability in depth that multi offers.....and maybee will have up-averaging vdi issues..... What are your thoughts on this?
      Take as a fact that, time efficient wise, both when inland hunting or beach hunting, I want to focus only in gold/silver rings and small to decent size coins, but eliminate all tiny 1-5mm micro staff (even if I lose a gold chain/earring on the beach or a really tiny hammered coin on the field)...With the Deus @8khz this strategy was working pretty good and I was able to hit even small thin silver 10mm hammered coins...but not the 1-5mm junk....what about the Nox, what would you propose?
      ps. Below, a sample of these tiny aluminum bits...they read at 12-15 vdi range so unfortunatelly I can's avoid them through notching cause I'll lose the gold also.
      So I need a strategy that eliminates by size (tiny ones) and not by conductivity!
      Best,
      Argyris
       
       

    • By PPP
      I hunt in salt water waste deep with both Garrett sea hunter(big coil) and Equinox .was disappointed about the depth i get with the Equinox compared to sea hunter.It does't even touch the depth i get with the sea hunter.It finds of course small stuff which sea hunter doesn't see at all but the depth is lacking.Don't know if i have to sell the Equinox or not,any help?
    • By canoe
      Thanks to Chase Goldman for telling me about the Equinox. Looks darn good to me, have read a number of reviews. Will order one today.
    • By GB_Amateur
      As mentioned previously, after rereading Dick Stout's Coin Hunting... In Depth book over the holidays I took his advice and stepped away from my standard sites to find new ones.  It seems to be working (thanks, Dick).  Statistics on that later in this post.  Last week I went to one of those 'new sites', a century old park, and in the first 2 hours I found 83 cents in modern coins searching along a road and around a crushed stone parking lot that had previously produced only one old coin -- a beat up Wartime nickel ('Warnick').  I decided to move to a picnic area for the last hour, and as you can see in the picture, I was rewarded.  (Sorry for the overexposure on the Warnick.)

      One of the Buffies showed up first, about 5-6 inches.  Next was the Merc at 4-5 inches.  The other two nickels followed (neither more than about 4 inches deep) and the big surprise was the Indian Head, also only about 4 inches deep.  My previous Personal Record ('PR') was only two old coins in one day's hunting.  Note that I don't count Wheat pennies in this category.  My single day PR there is 27.  Needless to say I was quite pleased.
      Oh, the 22 cartridge was found next to the above mentioned parking lot on a previous hunt.  Given that it's in a muni park (and we don't have gang problems..., etc.) I assume this was dropped long ago.  It's possible it was dropped after the park opened by a hunter who was getting his gear together after getting out of the car, before exiting the park on foot into the nearby woods.  The lead bullet appears to have 3 rings, one smooth and two serrated (if that's the correct word).  Can anyone put an age on this?  It was oriented vertically about 6 inches deep and sounded as sweet as any silver dime I've ever found, with the TID centered around 27.  Except for the 'P' on the back of the Warnick, there is no mintmark on any of the other coins.  The IH is 1903 and the Buffie dates are only partially visible.  I think one is 1916 and the other 1924.  None of these is scarce, but they still get counted in my 'other old coin' category.
      A little about the park.  As I mentioned it was established over a century ago.  I knew of its existence but figured so did every coin hunter within 100 miles.  Surely there was nothing left for me....  But another thing I've learned is that there is no such thing as "hunted out".  I've put 52 1/2 hours into hunting this park so far (all in 2020) and there's still more uncovered area awaiting.  Here are some numbers to mull over:  my 'other old coin' finds per hour is 0.27 for this site compared to 0.08 for all other hunted sites since beginning of 2017.  8 of the 14 finds are nickels.  Meanwhile Wheat pennies recovered per hour is 0.21, compared to 0.26/hr for all other sites starting in 2017.  And here is a sampling of my trash finds:

      These are from 12 1/2 hours of hunting this park.  All but a couple of the ring-and-beavertail pulltabs had Equinox TID's in the modern USA coin regions:  12-14 (nickels) and 19 and above.  If the nickel and pseudo-nickel target ID touches 15 I don't dig.  My custom high tone is 20 and up to make sure I notice Indian Head pennies.  (Note from the photo: I count Zincolns as trash and that's what the pictured discs are.)  The 14-18 region is typically thought of as pulltabs, but those in the photo (exception of a couple r&b's) all sounded and TID'ed like nickels.  The aluminum screwcaps TID 21-23.  Crown caps can be in both nickel zone and Zincoln zone (elsewhere, too), depending upon composition.  I did dig more trash than this, mostly can slaw but also some aluminum foil and the usual few bent nails, square nails, copper wire, etc.  This park is absolutely loaded with the old pulltabs, and the broken off beavertails are the worst.  It got to where I was requiring the TID to at least flash a 13 for me to dig 'nickels', and still you see what I pull out.  Unfortunately I later dug a pure 12 and it was a nickel.  😪  I wonder how many of those I left in the ground.
      If you're still here I hope you don't mind one more statistic:  for common coins of denomination 25 cents and less (so not counting Wheaties or other old coins, but including Zincolns), the fraction of nickels among common coins since beginning of 2017 (but not counting this site) is 15%.  At this site (again, not counting the eight old nickels) is 26%.
      In summary, I'm finding a lot of old coins compared to my other sites, but not more Wheaties.  I'm finding a lot more nickels (relative to other coins) than my other sites.  I'm finding tons of pulltabs in the nickel zone.  How does all this tie together?  Simple:  the site has been hunted by detectorists cherry picking the high conductors and ignoring the nickels because they don't want to dig pulltabs.  Of course they missed some Indian Heads (probably didn't want to be bothered with Zincolns either) and a few silver dimes.  Hopefully I'll find a higher denomination silver coin, but even if I don't I'm happy with the oldies that have been showing up.
    • By Bash
      After a bit of a drought of finding cool coins with the Equinox, I found another V nickel detecting in the neighbors parking strip in between thunderstorms.  It was pretty worn and pitted, and not of any numismatic value, so I cleaned it up a bit.


×
×
  • Create New...