Popular Post Toddbbq Posted March 8, 2018 Popular Post Share Posted March 8, 2018 Here is my completed EQ800 on a carbon fiber shaft project finally done. Now all I have left to do is finish my waterproof connector. 10 Link to comment Share on other sites More sharing options...
57buick Posted March 9, 2018 Share Posted March 9, 2018 info on the bipod legs? did you make that or order it somewhere? Link to comment Share on other sites More sharing options...
Toddbbq Posted March 9, 2018 Author Share Posted March 9, 2018 ordered.... pm me for more info as i do not know if i can post non sponsored vendors Link to comment Share on other sites More sharing options...
Toddbbq Posted March 9, 2018 Author Share Posted March 9, 2018 I ordered the bipod from metaldetector.com it is listed as makro racer series stand. Link to comment Share on other sites More sharing options...
Toddbbq Posted March 9, 2018 Author Share Posted March 9, 2018 You might be able to find something like it by searching for a plastic gun bipod... I think the inside diameter is 22-24 mm Link to comment Share on other sites More sharing options...
V3i/MXT Pro Posted March 9, 2018 Share Posted March 9, 2018 Which carbon shaft did you order from Anderson? Link to comment Share on other sites More sharing options...
strick Posted March 9, 2018 Share Posted March 9, 2018 11 minutes ago, V3i/MXT Pro said: Which carbon shaft did you order from Anderson? Just speculating but he might have had one laying around? I have one that I will try and make work.. anything in particular that was difficult about the job? someone was saying that you have to drill a little hole in the carbon fiber shaft for the nipple in the handle to drop into. strick Link to comment Share on other sites More sharing options...
martygene Posted March 9, 2018 Share Posted March 9, 2018 i'd like more info on the shaft if you would be so kind. what kind? where ? cost? i think i want to do that too so that maybe i can get a better balance so it's not so nose heavy. Link to comment Share on other sites More sharing options...
dewcon4414 Posted March 9, 2018 Share Posted March 9, 2018 It appears to be an Andersons upper at least. But i talked to Pete he said he was going to have to do this one from the ground up and that he had NOT gotten an EQ yet to do it. Todd..... been talking to Cliff about shafts and those connectors....... if you find a solution pass it to him please. Ive been told not to expect phones until MAY...... and they will come out even before the cables...... OF COURSE. I see you are using Harolds headphones. Did you use the NON-waterproof cable that came with the machine to add that M12 connector? Link to comment Share on other sites More sharing options...
Toddbbq Posted March 9, 2018 Author Share Posted March 9, 2018 I used a anderson at-pro shaft and had to drill a alignment hole for the eq pod and add some duck tape under it as it was a little loose. Dew i talk to cliff pretty much daily on the headphone connector. I used a mono headphone plug to the male ctx m12 connector but it is not waterproof Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now